Depending on the conditions selected, the appearances, dimensions, and mechanical properties of the molded products change considerably. set in a molding machine to obtain required moldings, and the number of combinations of conditions is innumerable. Molding condition means cylinder temperature, injection speed, mold temperature etc. See reprocessing properties of DURACON ® POM The position of change from speed control to pressure control is set at the point where either screw position or injection pressure reaches a certain fixed value. On the other hand, it controls dwell pressure after molten plastic fills out cavities. While molten plastic is flowing in a mold, the machine controls the moving speed of the screw, or injection speed. After the required amount of molten plastic is accumulated, injection process is stared. The screw is rotated to melt plastic introduced from the hopper and to accumulate molten plastic in front of the screw ( to be called metering ). The functions of the injection unit are to melt plastic by heat and then to inject molten plastic into a mold. There are 2 types of clamping methods, namely the toggle type shown in the figure below and the straight-hydraulic type in which a mold is directly opened and closed with a hydraulic cylinder. The functions of the clamping unit are opening and closing a die, and the ejection of products. Injection molding machine is divided into 2 units i.e. The process is proceeded as shown above and products can be made successively by repeating the cycle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |